Fix It

Explore » home» 1998 » a » accord » ball » fix » honda » how » in » joints » to » How to Fix Ball Joints in a 1998 Honda Accord

---

How to Fix Ball Joints in a 1998 Honda Accord

If you notice that your steering wheel is loose and sloppy when you drive down the road, you may have a worn upper ball joint and upper control arm. Unlike the case with lower ball joints, which require specialty tools that are quite expensive, a home mechanic can replace the upper control arm and ball joint in part of an afternoon.

Instructions

1

Loosen the lug nuts on both of the front tires. Do this before attempting to lift the vehicle off the ground or the tire will spin as you try to loosen them.

2

Raise the vehicle off the ground enough to lift the tires off the ground and place jack stands under the vehicle. Finish removing the tires once the vehicle is secure.

3

Remove the cotter pin from the upper ball joint using a needlenose pliers. You do not need to save the cotter pin; you will use a new one for installation.

4

Use the appropriate wrench to remove the castle nut at the top of the ball joint. Turn the wrench counterclockwise to remove the nut from the ball joint.

5

Separate the ball joint from the steering knuckle using a two-jawed puller and remove the upper control arm from the vehicle.

6

Install the new upper control arm assembly into the strut tower and connect the upper ball joint into the steering knuckle.

7

Install the tires onto the front of the vehicle and lower the vehicle to the ground.

8

Torque the nuts on the control arm and front wheels once the car is lowered to the ground. Torque the upper control arm to 47 foot-pounds. Next, tighten the castle nut to 32 foot-pounds and then tighten it enough beyond that point to install the new cotter pin. All of the wheel nuts should be tightened to 80 foot-pounds of pressure.