Sunday, February 23, 2014
How to Remove a 2000 Jeep Grand Cherokee Glove Box
Removing the glove box from the dashboard of your Jeep Grand Cherokee may be necessary if you are working on something behind the dashboard or if the glove box has damage to it that requires replacement of the entire assembly. You will not need any tools to remove the glove box, and the entire process takes just a few minutes to complete. Replacement components and assemblies are available from the parts department at any Jeep dealer.
Instructions
- 1
Open the glove box until the stops on the back edge are resting against the rubber stop bumpers in the upper glove box opening. Reach into the glove box and, with the middle finger of each hand, push the rubber flap on the two glove box stop bumpers toward the front of the vehicle.
2Roll the glove box door down until the stops on the back edge of the glove box pass through the openings in the upper glove box opening. Grasp both ends of the glove box door, then twist and pull the door as necessary to disengage the inboard hinge hook from the inboard hinge pin on the dashboard.
3Raise the glove box door until it is perpendicular to the instrument panel then twist the door slightly counterclockwise and shake the door slightly to disengage the remaining two hinge hooks from the instrument panel.
4Pull the glove box straight out of the dashboard. Set it aside in a safe place so you can reinstall it later if you will be reusing it.
