Sunday, October 27, 2013
Common Problems With the 1996 Nissan Maxima
The first Nissan Maxima was actually a top-trim Datsun 810; it reached U.S. shores in 1977. In 1981 the Maxima became its own model line; in 2010 the Maxima was in its seventh generation (eight if you include the Datsun 810 Maxima). The 96 Maxima, which has been known to have some common problems, is of the lines fourth generation.
Grinding Noise
Some 1996 Maxima owners reported a grinding in the rear brakes of their vehicles. Mechanics discovered that the parking brake kept pressure on the rear tires even after release. This required installation of new brake pads and a new brake cable.
Engine Knocking
There have been two causes identified from unusual engine noise in the 1996 Nissan Maxima. A reported "knocking" was found to be due to a defective on-board computer that had to be replaced. While a loose timing chain caused an unfamiliar "rattle." The timing chain fix required a new chain guide and tensioner.
Stalling Out
Corrosion on the cooling sensor of a 1996 Nissan Maxima has been found to be the cause of a stalling and hard-starting problem. This cooling sensor must be replaced to resolve the issue.
Poor Idle
Where electrical wires bend into the strut tower, mechanics have found broken wires that have caused failure in the starter and air conditioner. This hard bend of the wires into the strut tower has resulted in cut and broken wires in the 1996 Maxima.
