Wednesday, November 20, 2013
Nissan Altima Exhaust Hanger Installation
Exhaust hangers can vary depending on the year of the car. Make sure you purchase the right part for your year and model. To determine if your exhaust hangers need to be replaced, look to see if there are any cracks or tears in the rubber. Cracks and tears will allow the bracket attached to the muffler and muffler pipe to wobble back and forth. This can create additional noise from metal hitting metal and weaken your exhaust system due to excessive movement.
Instructions
- 1
Place a car jack under the designated area where the manufacturer recommends lifting the car. You can find this in the owners manual generally located in the glove box. Jack the car to a level you feel comfortable with to be able to move around under the car.
2Place a jack stand under the frame of the car. Lower the jack so the car frame rests completely on the jack stand. If you need more than one jack stand, repeat Steps 1 and 2. Note: It is recommended to leave the jack in an area that will support the car (with little pressure on it) in case a jack stand gives way. By doing this, you will have extra protection keeping the car from crushing you.
3Place your choice of ground cover under the car so you are not working on a dirty floor.
4Position the exhaust hanger bolt hole to match the position of the bolt hole located on the frame of the car. Screw in the bolt and tighten until secure with either the correct size wrench or socket. Note: Depending on the year of the car, the exhaust hanger could have one or two bolts.
5Slide the support bracket attached to the muffler or muffler pipe into the exhaust hanger. Make sure the support bracket is secure in the exhaust hanger. Repeat this step for all exhaust hangers.
6Remove the ground cover. Repeat Step 1 by raising the car with the jack and then remove the jack stand. Lower the jack and remove so the car is now resting on the ground.
