Thursday, May 8, 2014
How to Get the Replacement Key for a Dodge Truck
If you have lost the keys that came with your Dodge truck, you can contact a locksmith and they can attempt to cut a new key for you. However, they usually replace the lock cylinder in the doors and in the steering column. This can cost hundreds of dollars. There is a simpler and less expensive way to replace the key for your Dodge pickup truck.
Instructions
- 1
Locate the vehicle identification number (VIN) by looking at the dash through the lower corner of the window on the drivers side of the vehicle. The VIN number is also on your vehicle title, insurance card and registration card.
2Contact your local Dodge dealership and confirm that they have the ability to cut you a new key. Most dealerships offer repair services.
3Take your VIN number to the dealership. They can use the VIN number to look up the key code needed to duplicate your key.
Saturday, May 3, 2014
How Do I Install Replacement Wipers on a 2006 Jetta
Replacing the windshield wiper blades for a Volkswagen 2006 Jetta can easily be done by the owner. If the wiper blades are damaged, dirty or worn, they will not properly clean the windshield which can become a driving hazard. Checking the condition of your wiper blades the same time as you change the oil is a good rule of thumb. There are different styles of wiper blades for the 2006 Jetta that can be purchased from most auto parts stores or a Volkswagen dealership.
Instructions
- 1
Insert and turn the ignition key to the "On" position but do not start the engine.
2Press the wiper blade lever to the "On" position and turn the ignition key to the "Off" position. This will position the wipers on the windshield in order to access the blades.
3Pull the wiper blades away from the windshield into an upright position.
4Press the blade release button on the tip of the wiper arm.
5Remove one blade at a time by pulling down on the wiper.
6Slide the replacement blade onto the wiper arm until it clicks into place. Lower the wiper arm back onto the windshield.
7Insert and turn the ignition key to the "On" position but do not start the engine.
8Press the wiper blade lever to the "On" and "Off" position then turn the ignition key to "Off." This will place the wipers back in their normal operating position.
Sunday, December 8, 2013
How to Paint a Replacement Kool Vue Mirror
Car mirrors can endure a lot of damage, even in normal driving conditions. When a broken mirror must be replaced, they often come unpainted and must be painted before installation. Many replacement mirrors are manufactured by Kool Vue, so if you purchase a Kool Vue mirror its important to know the proper way to paint it for the best results.
Instructions
- 1
Cover the glass portion of the replacement Kool Vue mirror with newsprint.
2Secure the newsprint in place with masking tape.
3Clean the entire surface of the plastic to be painted with mineral spirits applied with a clean lint-free cloth. Allow the mineral spirits to dry completely before continuing.
4Sand the entire surface of the plastic to be painted with 800 grit sandpaper and water. Keep the sanding surface moist as dry sandpaper can damage the plastic.
5Wipe away any excess sanding debris with a clean lint-free cloth.
6Apply plastic primer, also called "adhesion promote," to the entire surface to be painted. Allow the primer to dry fully according to manufacturer instructions.
7Apply a second coat of plastic primer to the entire surface to be painted. Allow the primer to dry fully according to manufacturer instructions.
8Paint the entire surface of the plastic to be painted with automotive paint. Allow the paint to dry fully according to manufacturer instructions.
9Remove the masking tape and newsprint from the glass portion of the mirror.