Showing posts with label diy. Show all posts
Showing posts with label diy. Show all posts

Monday, April 28, 2014

DIY Car Amp Repair

DIY Car Amp Repair

There are a variety of reasons why a car audio amplifier might malfunction, most of which render the amplifier useless until it has been fixed. Most car amplifiers are fitted with a function that completely shuts the amp down if there isnt a complete circuit connected to the amplifier, but it may not help you fully diagnose the problem. Most problems lie within the wires themselves, so making sure theyre repaired and working properly is key.

Instructions

    1

    Find the red wire on the left side of the amplifier. Connect one end of the voltmeter to this wire and the other end to a piece of exposed metal. This should make a complete circuit. If the amplifier does not power on following this, then the problem may be with the amplifiers wiring.

    2

    Find the ground wire at the back of the amplifier. The wire is black and should be attached to a piece of exposed metal. Apply a piece of electrical tape to the ground wire and attach it firmly to a piece of exposed metal if not already connected. This creates a full circuit.

    3

    Remove the white fuse from the fuse terminal located on the left of most amplifiers and replace it with a new one. A blown fuse will generate no power for the amplifier, rendering it useless.

    4

    Stick pieces of electrical tape to each wire that is coming out and into the back of the amplifier. Each wire is partially exposed at one section to allow a connection to the fuse terminal. However, this can cause short circuits, and the connection between these wires and the fuse terminal isnt vital as it is powered by the main wire running on the side of the amplifier.

Read here..

Sunday, March 30, 2014

DIY Harmonic Balancer Removal in a Chrysler Sebring

The Sebring was a series of mid-size cars that Chrysler produced from 1995 through 2010. The crankshaft in this vehicle has a harmonic balancer, like most modern combustion engines. The harmonic balancer is essentially a counterweight that reduces the vibrations that occur when the crankshaft rotates at high speed. The procedure for removing the harmonic balancer in a Chrysler Sebring requires you to lift the engine to access it.

Instructions

    1

    Remove the cable from the negative battery terminal with a socket wrench so you dont inadvertently start the engine during the removal process.

    2

    Place a wooden block on a floor jack to serve as a cushion. Position the floor jack under the oil pan and raise the jack to support the engine.

    3

    Disconnect the three vertical mount bolts on the right side of the engine with a socket wrench. Lower the floor jack and reposition it so you can raise the entire vehicle while getting access to the oil pan. Raise the vehicle with the floor jack and support it on jack stands.

    4

    Unscrew the lug nuts from the right front wheel with a lug wrench then pull off the wheel. Remove the splash shield for the drive belt with a socket wrench.

    5

    Place a wooden block on a screw jack, and position the screw jack under the oil pan. Support the engine with the screw jack and disconnect the front and rear through-bolts for the engine mount with a socket wrench.

    6

    Lower the engine with the screw jack and detach the accessory drive belts from their pulleys. Disconnect the mounting bolt for the harmonic balancer with a socket wrench.

    7

    Connect special tool 8454 to the harmonic balancer and attach insert 6827-A to the special tool. Pull the balancer from the crankshaft.

Read here..